Open the Kiosks’ back door

Plug and power cable and terminal cable together

Plug the power cable into the power plug inside the Kiosk

Insert the terminal plug end through the hole on the Right of the Kiosk; pull it further enough you can work with the cable

Unscrew the side screws on the terminal mount to remove the small metal plate

Insert the cable hanging outside the kiosk through the Terminal holder

Plug the cable into the terminal (at this point, the cable will be coming out of the Kiosk and attached to the terminal - screw it shut to secure the cable and connector.

Screw the small metal plate onto the terminal, with the hook side on the Card swipe side.

Hook the terminal metal hook onto the main terminal holder and screw it together

Pull the cable through carefully so its finishes looking like the image below

Attach the terminal mount to the side and mount it using the nuts on the side. Ensure all four nuts are secured tightly so the unit does not become loose

Power on the Kiosk, and the terminal should start its processing to connect to Wifi, etc.

IMPORTANT: Then neatly secure and rollup cables inside the unit with ties so they don’t touch moving parts or other hardware